The setup register values. The i21554 device can be programmed by an on board serial prom that will initialize the setup registers. In Simics this is done by setting this attribute. The seven registers are in the following order: downstream memory 0, downstream I/O / memory 1, downstream memory 2, downstream memory 3 (lower), downstream memory 3 (upper), upstream I/O / memory 0 and upstream memory 1.
List of all current PCI I/O and memory mappings.
Chip Control 0 register.
Register info for all registered configuration registers. The format for each entry is (offset, name, size, write-mask).
The 64 PCI configuration registers, each 32 bits in size.
Downstream configuration address register.
ROM object, map size, and map function number for the Expansion ROM.
State of the interrupt pin.
List of all current PCI IO and memory mappings.
The PCI bus this device is connected to, implementing the pci-bus interface.
Secondary interface object for the bridge
Write masks for all registered configuration registers. The format for each entry is (offset, mask).