(b0, ..., b16). Current command.
Currently executing command.
Actual length of current command.
Command busy (main status bit 4).
Number of command bytes received.
Current result read position.
Data transfer direction (main status bit 6).
DMA device, implementing the common-dma interface.
DMA enable flag.
Currently selected drive.
((drive)*). List of up to four floppy drives.
Controller enable flag.
FIFO enable flag.
Head load time.
Head unload time.
Implied seek enable flag.
Interrupt request status.
Interrupt device, implementing the simple-interrupt interface.
Polling change detected.
Polling mode enable flag.
Controller is ready to receive data (main status bit 7).
(b0, ..., b14). Result bytes.
Number of result bytes.
Status register 0.
Status register 1.
Status register 2.
Floppy command state. Idle=0, Command=1, Execute=2, Result=3.
Step rate interval.
|info||print information about the device|
|insert-floppy||insert floppy in drive|
|status||print status of the device|
The -rw flag uses floppy-image in read-write mode, meaning that no save or save-diff-file command to the associated image object need to be used in order to save data written by the target software.